The headphones cannot connect to the Bluetooth device using one-touch connection (NFC).
IMPORTANT: This article applies only to specific products and/or operating systems. Check the Applicable Products and Categories section of this article before starting these steps.
Check the following:
- Remove the headset from the charging case and make sure that the headset is turned on.
NOTE: You cannot make a one-touch connection (NFC) when the headset is inside the charging case because the headset is off.
The image below is an example of WF-1000XM3.
- Keep the smartphone close to the charging case until the smartphone reacts. If you fail to connect, move the smartphone slowly on the N-Mark of the charging case.
- Check that the NFC function of the smartphone is set to on.
- If the smartphone is in a case, remove it.
- NFC reception sensitivity varies depending on the device. If you repeatedly fail to connect the headset with a smartphone by one touch, connect it to the headset by on-screen operation on the smartphone.