Article ID : 00261171 / Last Modified : 26/05/2022

How do I use Wi-Fi tethering in the 5GHz band?

    IMPORTANT: This article applies only to specific products and/or operating systems. Check the Applicable Products and Categories section of this article before starting these steps.


    To use Wi-Fi tethering in the 5 GHz band.

    1. Find and tap Setting → Network and Internet → Hotspot and tethering → Portable hotspot.
    2. Tap AP band and select 5 GHz band preferred.
    3. Tap the slider on the top turn it ON (blue)

    Note: Immediately after starting Wi-Fi tethering, you cannot connect from the client device for up to 3 minutes for checking the presence of radar in the 5 GHz band, so please connect after the notification of "5 GHz portable hotspot is available" is displayed.

    Also, if radar is detected in the 5 GHz band during Wi-Fi tethering, the communication between the client devices will be disconnected, but after a while, the client devices will automatically reconnect.

    In either case, "5 GHz band preferred" Wi-Fi tethering operates in the 5 GHz band if there is a frequency that can be used in the 5 GHz band, and operates in the 2.4 GHz band if the frequency in the 5 GHz band cannot be used.